1783 NATR Switch

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #3683
    jctingsonJames Kevin Tingson
    Participant
      Karma: 33
      Rank: Padawan

      H I need help, I have this set up

      PC- ip address is 10.104.43.123, 255.255.255.0

      NATR-Public ip address is 10.104.43.217, 255.255.255.0
      -Private ip address is 192.168.0.85, 255.255.255.0
      NAT Rule: 10104.43.216 > 192.168.0.80

      PLC- ip address is 192.168.0.80, 255.255.255.0

      what should I do since I cannot ping my plc?

      PS: I should not put gateway address to my PLC.

       

      Thanks

      -james

      #3684
      PLCGuruPLCGuru
      Keymaster

        Hi James and welcome to the forums!

        I’m a little confused by why you say you should not put a gateway address in the PLC? For NAT translation to work you need to setup the gateway translation which requires a gateway address in the PLCs. Perhaps it’s not clear what you were trying to communicate. Our moderators are ready to help!

        #3686
        jctingsonJames Kevin Tingson
        Participant
          Karma: 33
          Rank: Padawan

          I cannot put gateway address in PLC because it has a password and the end-user doesnt want to redownload the program because a fault may occur. So now, Im having troubles to communicate with the plc thru 1783-NATR switch. I have read some conversation about making a rule to the PC’s ip address, and they dont need to set gateway to plc, and Im asking if it is possible.

           

          #3687
          AlexAlex Cuningham
          Participant
            Karma: 14
            Rank: Padawan

            The key is to make sure you can see devices on the public side and private side with RS Linx. You did not say whether you created a standard Ethernet driver in RS Linx and then created mapping for the driver.  You must do this step to allow RS Linx to route the traffic.

            If you cannot see the device in RS Linx, no mapping is going to take place.

             

            regards,

            Alex

            Attachments:
            You must be logged in to view attached files.
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.