Viewing 1 post (of 1 total)
  • Author
    Posts
  • #20201
    rhouseknecht
    Participant
    Karma: 26
    Rank: Padawan

    AB Device net motor control. I change drive parameters and apply but when we have a surge or lose of power my changes are no longer there.

    Is there a solution. Ab no longer supports the drive I’m using. Its a 160. I have replaced the drive so I’m sure its not an issue with the drive.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

This website uses cookies.