Remote I/O P&ID Symbol

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #3913
    redmercuryredmercury
    Participant
      Karma: 42
      Rank: Padawan

      Hi, here at the office we’ve been having a discussion about what P&ID symbol to use on our AB Flex I/O modules. Any help would be greatly appreciated.

      Thanks.

      #3915
      mrincrediblemrincredible
      Participant
        Karma: 53
        Rank: Padawan

        Hi Ramon,

        When you refer to P&ID, I assume you are referring to Piping & Instrumentation Diagrams and not PID (Proportional Integral Derivative)…there is a difference. Assuming that’s clear, I are you required to show the actual IO points in the P&ID? Typically these are more abstract type drawings that do go right down to the IO. Could you not just show the controller and then have a note beside?

        Cheers

        #10802
        s8ivas8iva
        Participant
          Karma: 16
          Rank: Padawan

          I have attached a screenshot from one of our electrical schematics. We used flexIO.

        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.