Device Net › PLCGurus.NET Live & Interactive Forum › PLC Questions and Answers › General Automation Questions › Device NetThis topic has 0 replies, 1 voice, and was last updated 2 years ago by rhouseknecht.Viewing 1 post (of 1 total)AuthorPosts May 21, 2021 at 9:22 pm #20201 rhouseknechtParticipantKarma: 26Rank: PadawanAB Device net motor control. I change drive parameters and apply but when we have a surge or lose of power my changes are no longer there.Is there a solution. Ab no longer supports the drive I’m using. Its a 160. I have replaced the drive so I’m sure its not an issue with the drive.AuthorPostsViewing 1 post (of 1 total)You must be logged in to reply to this topic.Log In Username: Password: Keep me signed in Register Log In