Integrating existing expansion module to new Schneider M172 hvac controller

› PLCGurus.NET Live & Interactive Forum › PLC Questions and Answers › Miscellaneous Automation Controllers › Integrating existing expansion module to new Schneider M172 hvac controller

Tagged: ,

  • This topic has 1 reply, 2 voices, and was last updated 5 years ago by PLCGuruPLCGuru.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 14, 2018 at 1:07 pm #1904
    m_foster76Mark Foster
    Participant
      Karma: 13
      Rank: Padawan

      Good afternoon,

      Just wondering if anyone has ran into any issues integrating/pairing a new M172 (TM172PDG42R) hvac plc to an older expansion module of the same series.   There is no firmware number listed on expansion module but the new plc has a higher firmware number.   Currently waiting on Schneider support, but the current situation is plc sees expansion but expansion does not respond to commands through Can Open comm’s.

      Attempting to upload older firmware with same program but figured Id post in the meantime.

      Thanks in advance!

      mark

      May 14, 2018 at 8:34 pm #1914
      PLCGuruPLCGuru
      Keymaster

        Hi Mark, and welcome to the forums! I’m not familiar with the Schneider series you speak but wanted to personally welcome you to the site. Hopefully someone else here can help or better yet you’ve sorted it out in the meantime. If you do find a solution, you’d be doing others a service by sharing your fix.

        Again, welcome to PLCGurus.NET and thank you for registering!

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.